Zoeller® 267-0004 Waste-Mate 260 Submersible Pump, 1/2 hp, 230 VAC, 2 or 3 in NPT Outlet, Cast Iron, 5.5 A, 1 ph
- Amperage Rating: 5.5
- Bearing Type: Sleeve
- Cord Type: 3-Wire Neoprene
- Dimensions: 14-5/16 in H
- Flow Rate: 128
- Frequency Rating: 60
- Horsepower: 1/2
- Impeller Type: Non-Clogging Vortex
- Material: Cast Iron
- Maximum Head: 21-1/2
- Motor Speed: 1750
- Outlet Size: 2 or 3 in NPT
- Series: Waste-Mate 260
- Temperature Rating: 130
- Voltage Rating: 230
- Phase: 1
Zoeller® Submersible Pump, Series: Waste-Mate 260, 128 gpm, 2 or 3 in NPT Outlet, 21-1/2 ft Maximum Head, 1/2 hp, 230 VAC, 5.5 A, 60 Hz Frequency, 1 ph ph, 1750 rpm Motor, 3-Wire Neoprene Cord, Non-Clogging Vortex Impeller, 130 deg F, Sleeve Bearing, Cast Iron, 14-5/16 in H Dimensions
Considered one of America's most popular sump pumps. This robust family of sump pumps is known for reliability, durability and performance. The preset, integral snap-action float switch is engineered for one million mechanical starts. The heat-dissipating cast iron body with epoxy powder coated finish provides maximum pumping performance under the most extreme conditions. With Zoeller® cool run design, the hermetically sealed, oil-filled motor and non-clogging vortex impeller add up to a long-lasting, trouble-free product.
- Features
- Float operated 2-pole mechanical switch
- Durable cast construction, ASTM Class 25 cast iron switch case and pump housing
- Non-clogging vortex impeller design, engineered plastic impeller with metal inserts (1 ph)
- Not affected by materials normally found in drainage and sewage pumps
- Stainless steel screws, bolts, handle, guard, arm and seal assembly
- Neoprene square ring and gasket
- Oil filled, hermetically sealed motors
- Oil-lubricated bearings
- Carbon and ceramic shaft seal
- Corrosion-resistant, powder coated epoxy finish
- Completely submersible
- Watertight and dust-tight
- Automatic reset thermal overload protection (1 ph only)
- 12 in on point, 4 in off point
- High water alarms available
- 10 in auto/15 in non auto, 3-wire neoprene cord and plug
- Cap/motor housing/pump housing cast iron, base cast iron or engineered plastic
- Upper and lower sleeve bearing
- Engineered plastic with metal insert impeller, Stainless steel hardware, AISI 1215 cold rolled steel motor shaft, Neoprene gasket
- Submersible sewage/effluent or dewatering pump
- Standard/Approvals: cSAUS Certified|UL Listed